EVDash is a Palm OS application that acts as a set of dash board gauges for electric vehicles. It displays battery pack voltage, amps being drawn from the battery pack, and two different estimates of remaining battery capacity. It works with Xantrex's Link 10, formerly called the E-Meter. Just plug the Palm device into the E-Meter, preferably through an optical isolator to protect the Palm device and start the EVDash program.
- Voltage - Battery pack voltage.
- Amps - Amps being drawn from or put back into the battery pack.
- Capacity based on voltage - Capacity calculated from the pack voltage under very low load. Voltage drops off as pack capacity drops.
- Capacity based on amps - Capacity calculated from the amps drawn integrated over time compared to the pack capacity. The peukert effect is taken into account.
Once you install the EVDash.prc on the Palm pull down the menu and go to the setup window. Enter the pack capacity and the Peukerts constant. The state of charge voltages should be determined experimentally by recording the voltages as the battery pack is completely discharged.
To transfer ASCII data from your Palm, use the standard Hot sync cable and a terminal program. Set the following communications information:
Supported operating systems:
Palm OS 3.x, Palm OS 4.x, Palm OS 5.x
Similar Software:
TealScript Plus TealScript Plus - Graffiti Reinvented
Replace or restore Graffiti with TealScript, the text recognition system you can customize. Unlike Graffiti or other systems, TealScript lets you make or change your own strokes for better speed and accuracy
STOIC (STay On In Cradle) STOIC (STay On In Cradle) is used to force your PDA to stay on when charging via the cradle or cable.
This solves issues with handhelds that don't have a "stay on" option or for situations where the stay on option isn't working properly.
Works on most old and new palm models (OS 2.0 and above)
BigButton BigButton - If you have your hands full and you can't use the stylus to jot down important numbers e.g. when you're driving or on the phone, launch BigButton.
You can easily push the big buttons on your Palm screen using your fingers (pointer or thumb).
No need to pull-out your stylus! It easily memorizes 80 digits that can be seaprated by "
PowerDA A DA to simulate pressing the power button on your device
PalmBuzzer PalmBuzzer allows you to set sound to the 4 hardware buttons, to letters and numbers and to add a picture on top of the window.
These are the naming rules at the moment:
Every file needs to be a WAVE audio file and stored in /PALM/Programs/PalmBuzzer/
* for the 16 on-screen buttons: Test1.wav to Test16.wav
* for the 4 hardware buttons: Hard1.wav to Hard4
PButton If the device is switched off for at least the preset time then selected application is launched after next powering up using power button
EVPlugBase EVPlugBase is a hack controller that has long been an extremely popular alternative to Hackmaster as a means of controlling hacks
AlwaysOn (Palm OS) AlwaysOn (Palm OS) is a simple little application that lets you change the auto-off time of your Palm to some different values than possible with the built-in preferences. Especially it is possible to disable the timer completely.
What's New in This Release:
· Added color icons, confirmed compatibility with OS 3
PointerHack PointerHack is a HackMaster utility which allows you to control a pointer via a keyboard which can be used to point and click on the Palm.
With these tool, hopefully you won't have to use a stylus with your keyboard again.
GNU C Source is included free
Other Software by developer «Peter Ohler»:
EV1Dash EV1Dash is a program for Palm OS devices that will collect data from the EV1 and display it on the Palm OS device display. The intent is to provide more information to the driver so that range and performance can be optimized. Here is one of the displays. There are two other displays
